Part B document generation fixes & improvements go live!

Hi there,

The automatic generation of Part B documents for Design Approval applications has been updated 🙌.

Based on feedback we've made the following fixes and improvements:

• Insert engine torque speed graphs into correct section within document (previously attached to the end of the document)
• GCM (from the Assessment application step) is added to the Vehicle Physical Characteristics > Mass section of the Part B. If there are multiple GCMs, the maximum GCM should be used.
• For all Couplings in the Vehicle Specifications > Coupling section, if rear checkbox is checked add ‘Rear’ to description after ‘(minimum)’ label with a space.
• Insert space between unit of measurement and ‘kN’ label for couplings.
• Add unit for Driveline clutch engagement after numeric value (with space between).
• Add thousands separator to value for Driveline clutch engagement.
• Maintain aspect ratio of images included in DA applications that are transferred to Part B.
• Populate Power (hp) and Torque (lbf.ft) in Part B when populated in UI.
• Remove kW and Nm labels from Part B when not populated in UI.
• When steer or drive checkboxes are checked, add a prefix to relevant row in the Part B.
• Add notes for differential to Part B.
• Add note for gearbox to Part B.